The following settings are intended for use on VIP Conduit.
Pressing F4 will place you in the first box of the General Tab.
If your voice activation is turning itself on and you have been frequently removed from a room, drop to the last heading on this page.
Type your nickname Where it says no name.
pressing the tab key will place you in a combo box,
select male or female.
Press tab again,
This is where the length of time before you are set to away status is adjusted.
It is set to 180 seconds this should bee fine.
Press tab,
Disabled voice Activation while inactive, make sure this is checked.
Press tab
Speech transmission mode push to talk, this should be checked.
Press tab
Speech transmission mode, set up keys button, press the space bar, now hold down the key that you wish to use for your talk key, you must hold it down for about 7 seconds, most people use the left control key.
Press tab
Here it will say the name of the key that you set.
Now press tab again.
Speech transmission Voice Activation, make sure this is unchecked.
Press tab to the ok button and press the space bar.
This completes the general tab.
Changes not recommended here.
Changes not recommended here.
Tab from one item to the next.
The first three items relate to your input and out put devices. We recommend leaving these alone unless they aren't working, as the defaults will usually work.
The next item is a test button. Pressing the space bar on this will allow you to hear if things are working. Tap the space bar again to stop.
The next item enables the Automatic Gain Control. We suggest making sure this is unchecked. When checked it often makes you very loud when you first enter a room before it turns you down.
The next item is enable noise reduction. This suppresses extraneous noise from your microphone, we suggest checking this.
The next item is Media volume versus voice volume. We recommend setting this between 15 and 30, this is how lowd you hear other peoples music.
The next item is the default button. This will return settings to the default settings.
Last, tab to Ok and press enter.
In this tab you will need to tab once to the first box and then use the arrow keys to view the options. Tap the Space Bar to check or uncheck these boxes.
Only 3 items under the Sound events tab should be checked They are listed below.
Enable voice activation
Disable voice activation
Transmit ready in "no Interruptions"
Tab to Ok and press enter.
Tab to the first box and then use arrow keys to view choices. We suggest un checking the first four as leaving them checked will cause you to hear a lot of unnecessary information. The remainder should probably be left alone at least until you have used the client for awhile. Tab to Ok and tap the space bar to save the changes.
The items in this tab allow you to create or change shortcuts for various functions. Simply Tab to move through the items. If a shortcut already exists the name of the key will appear followed by a clear button. To reset the key tap the space bar on the clear button. Tab once and you'll find a setup key button. Tap the space bar and then hold down the key or keys you wish to use for roughly 5 seconds. Tab to ok and tap space bar or press enter to save the change.
No changes should be necessary here.
No changes should be necessary here.
You may set voice activation to not come on automatically by following these steps If you are repeatedly being kicked out of a room, this is what you need to check. In order for this to work Voice Activation must be on. Use your already chosen lock key or Control Shift A to turnit on.
Next Tab down until you find Voice Activation Level. This needs to be set to 0. Once you've done this you may turn off voice activation and close out of the window. Now Voice Activation will work only if you turn it on with your preset key or Control Shift A.
Updated on ... October 06, 2018